Model LT62FR includes:
Model LT61QD DIN rail transmitter by Laurel Electronics has Dual channel pulse or AC inputs configurable for frequency, rate, rotal, or timing., 4-20 mA or 0-10V analog output plus RS232 or RS485 I/O and dual relays. The model is configured for Standard main board and Power over Ethernet. It can be programmed for frequency, rate, period, totalizing, and timing.
The Laureate dual-channel frequency, rate and period transmitter is for frequency from 0.005 Hz to 1 MHz, rate in engineering units, or period (inverse of frequency). Values can range to 999,999 counts. Applications include the accurate transmission of AC line frequency, RPM, speed from proximity switch inputs, and flow from turbine flow meter inputs. The Laureate counter determines frequency by timing an integral number of periods over a specified gate time, and then taking the inverse of period.
The Laureate dual-channel up or down totalizer may be independently set up and scaled to count up from zero (or other value) to a preset limit, or to count down from a preset value to zero (or other limit). Countdown operation is set up by entering a negative scale factor. The totalizer can display values from -999,999 to 999,999 with a programmable decimal point. Scaling allows direct readout in engineering units. Totals are stored in non-volatile memory so as to be retained in the absence of power.
The Laureate stopwatch transmitter times single events which produce start and stop pulses. It can also time the width of a single pulse. Highest resolution is 0.2 us. The event time may be displayed H, M or S format with six-digit resolutionor or in HH.MM.SS clock format with 1 s resolution. The stopwatch display is updated during timing. Accumulated time from multiple events is also tracked and may be displayed to 999,999 hours.
The Laureate A-to-B Time Interval Meter can display pulse width or time delay between individual pulses to a resolution of 0.2 µs. It can also display average pulse width or average time delay between multiple pulses. Time interval is measured between inputs on channels A and B. Time interval can be displayed in seconds, milliseconds, or microseconds with 6-digit resolution.
The FR dual-channel signal conditioner accepts inputs from proximity switches w ith PNP or NPN output, TTL or CMOS logic, magnetic pickups, contact closures, low-level outputs from turbine flow meters down to 12 mV, and high-level AC line inputs up to 250 Vac. A built-in isolated 5, 10, or 24 Vdc excitation supply can power proximity switches and other sensors, thus eliminating the need for an external power supply.
LTM Series serial output transmitters send data via an isolated serial port, which is user configurable for RS232 or RS485 and full or half duplex operation. Three protocols are user selectable: Modbus RTU, Modbus ASCII, or Laurel ASCII. Modbus operation is fully compliant with Modbus Over Serial Line Specification V1.0 (2002). The Laurel ASCII protocol allows up to 31 Laureate devices to be addressed on the same RS485 data line. It is simpler than the Modbus protocol and is recommended when all devices are Laureates. It also allows use of Laurel Datalogging Software.
Standard features of Laureate transmitters include:
For detailed transmitter information, specifications, dimensions and pricing, visit the following: