Call (714) 434-6131 for Product Assistance
Transmitters, 4-20 mA & Modbus - Panel Meters - Counters - Timers - Ethernet - USB - RS485 - RS232

LTE60QD DIN Rail Transmitter with Ethernet I/O, 4-20 mA Analog Output, and Dual Relays

Quadrature input for length or position, Ethernet I/O plus 4-20 mA or 0-10V analog output and dual relays

Model LTE60QD includes:

  • Quadrature input for length or position
  • 4-20 mA or 0-10V isolated analog output
  • Modbus or ASCII serial data output
  • Universal 85-264 Vac power
  • Two 120 mA solid state relays

  • 35 mm DIN rail mounting

Model LTE60VF4 DIN rail transmitter by Laurel Electronics has Quadrature input for length or position, Ethernet I/O plus 4-20 mA or 0-10V analog output and dual relays. The model is configured for Standard main board and Universal 85-264 Vac power. It accepts A & B quadrature encoder signals to provide an analog output that tracks position, length, or angle. The A & B quadrature signals are 90 degrees out of phase, and their phase relationship determines whether up counts (+) or down counts (-) are produced.

One, two or four quadrature transitions may be counted at a maximum combined rate of 250 kHz and be scaled internally to ±999,999. counts. The input circuitry which may be jumpered for either single-ended input signals or for balanced line driver signals. Anti-jitter circuitry eliminates errors produced by vibration of the encoder. In the event of a power failure, the current total may be stored in non-volatile memory and can be used as the starting point for counting when power resumes. Power fail or zero index capabilities are alternate meter setup choices.

A zero index pulse, if available, is interpreted by the meter as indicating a zero reference for an integral number of revolutions of a rotary shaft encoder or the home position of a linear encoder. It is used by the meter for initializing and to correct for any cumulative pulse count errors. Special circuitry corrects for width of the zero index pulse.

Three analog output transmitter settings are jumper selectable: 4-20 mA, 0-20 mA or 0-10V. The output tracks the reading up to 99,999 counts that would be transmitted digitally. Output isolation from signal and power grounds eliminates potential ground loop problems. The supply can drive 20 mA into a 500 ohm (or lower) load for 10V compliance, or 10V into a 5K ohm (or higher) load for 2 mA compliance.

Standard features of Laureate transmitters include:

  • Analog transmitter output, 16-bit, user scalable and isolated. User selectable 4-20 mA, 0-20 mA or 0-10V levels.
  • Serial communications, isolated. User selectable RS232 or RS485, half or full duplex, Modbus or Laurel ASCII protocol.
  • Dual solid state relays for control or alarm, isolated. Rated 120 mA at 130 Vac or 170 Vdc.
  • Transducer excitation output, isolated. User selectable 5V@100 mA, 10V@120 mA or 24V@50 mA.
  • Universal AC power supply for 85-264 Vac.

For detailed transmitter information, specifications, dimensions and pricing, visit the following:

Legal Information
seal-20th17    
facebook   G+   twitter   linkedin
© 1990-2017 Laurel Electronics, Inc.