Alarm Notification (Sec)

Node Help Overview
 
Device Setup Pages:
 
Select Device
 
Change Device Name
 
Node Protocol
 
Baud Rate
 
Parity
 
Alarm Notification
 
Alarm Dwell Time
 
Alarm Mask: 1, 2, 3, 4
 
Data Email Interval
 
URL Refresh
 
Force Default

 An alarm notification email can be sent to all email recipients each time the alarm status of a device connected to the Node changes. To reduce the number of emails, this interval in seconds dictates the minimum time between consecutive emails. Alarm emails are disabled by entering an interval of 0.

Press GO to enter any changes.

Background:  The Device Interface Setup screen applies to the Node whose MAC address is shown in the top right of the screen. That Node is selected by clicking on Setup on the Node Discovery screen. If the selected Node is an Ethernet I/O board of a meter, only that single host meter will be discovered as the device for that Node. If the selected Node is an Ethernet-to-serial device server option board of a meter or is a DIN-rail Ethernet-to-serial device server, up to 31 physical devices may be discovered, including the Node itself. Since Modbus allows addresses of 1-247, there can be unused addresses.