Alarm Mask: 1, 2, 3, 4

Node Help Overview
 
Device Setup Pages:
 
Select Device
 
Change Device Name
 
Node Protocol
 
Baud Rate
 
Parity
 
Alarm Notification
 
Alarm Dwell Time
 
Alarm Mask: 1, 2, 3, 4
 
Data Email Interval
 
URL Refresh
 
Force Default

 Check any boxes 1, 2, 3, 4 to receive alarm email mail notifications from any alarms 1, 2, 3, 4 the selected devices connected to the Node. If the device is one of our meters (DPM or counter), it will have 2 or 4 alarms if a 2 or 4 relay board has been installed. If it is one of our LTA or LTM transmitters, it will have 2 solid state alarms, which are standard. Not all alarms may be of interest for email notification. To remove an alarm from alarm email notifications, uncheck that alarm.

Press GO to enter any changes.

Background:  The Device Interface Setup screen applies to the Node whose MAC address is shown in the top right of the screen. That Node is selected by clicking on Setup on the Node Discovery screen. If the selected Node is an Ethernet I/O board of a meter, only that single host meter will be discovered as the device for that Node. If the selected Node is an Ethernet-to-serial device server option board of a meter or is a DIN-rail Ethernet-to-serial device server, up to 31 physical devices may be discovered, including the Node itself. Since Modbus allows addresses of 1-247, there can be unused addresses.